Enabling Caller ID Generation and Detection on Tel Side
The device's Caller ID support depends on the type of analog interface:
|
■
|
FXS interfaces: The device sends (generates) the Caller ID signal to the device's FXS port. |
You can enable Caller ID generation (FXS interfaces) per port in the Caller ID Permissions table (see Configuring Caller ID Permissions). For ports that are not configured in the table, Caller ID is according to the global parameter, as described in the procedure below.
The following procedure describes how to enable Caller ID for all analog ports.
|
1.
|
Open the Supplementary Services Settings page (Setup menu > Signaling & Media tab > Gateway folder > DTMF & Supplementary > Supplementary Services Settings). |
|
2.
|
From the 'Enable Caller ID' drop-down list (EnableCallerID), select Enable. |
Additional Caller ID parameters includes the following:
|
■
|
CallerIDType: Defines the Caller ID standard. The configured standard Caller ID must match the standard used on the PBX or phone. |
|
■
|
BellcoreCallerIDTypeOneSubStandard: Defines the Bellcore Caller ID sub-standard. |
|
■
|
ETSICallerIDTypeOneSubStandard: Defines the ETSI FSK Caller ID sub-standard. |
|
■
|
EnableCallerIDTypeTwo: Enables generation of Caller ID type 2 when the phone is off-hooked (used for call waiting). |
|
■
|
AnalogCallerIDTimimgMode: Defines the time period when a Caller ID signal is generated. By default, Caller ID is generated between the first two rings. |
|
■
|
PolarityReversalType: Defines reversal polarity and/or wink signals for Caller ID signals. It is recommended to configure the parameter to 1 (Hard). |
|
■
|
UseSourceNumberAsDisplayName and UseDisplayNameAsSourceNumber: Defines Caller ID interworking. |